Masonry Wire Fabricated Corners
Technical Product Data Sheet
Description
OCM, Inc's Masonry Wire Fabricated Corners are used with Masonry Wire Ladder around 90 degree turns.
Features
- Available in mill galvanized and hot dipped galvanized.
- Available in 8" and 12".
| OCM Part No. | Description | Qty Per Bundle |
|---|---|---|
| MWLMC-8MG | 8” MILL GALV CORNER - 32” X 32” | 25 |
| MWLMC-8HDG | 8” HOT DIP GALV CORNER - 32” X 32” | 25 |
| MWLMC-12MG | 12” MILL GALV CORNER - 32” X 32” | 25 |
| MWLMC-12HDG | 12” HOT DIP GALV CORNER - 32” X 32” | 25 |
Material Conformance
ASTM A951/A951M - (Standard Specification for Steel)
Wire For Mason Joint Reinforcement
ASTM A82/A82M - (Cold Drawn Steel Wire)
Tensile Strength - 80,000 psi
Yield Point - 70,000 psi
Coatings conform to the following specifications:
ASTM A641/A641M (0.1 oz/Ft2 ) for Mill Galvanized coating
ASTM A153/A153M-B2 (1.5 oz/Ft2 ) for Hot-Dip Galvanized
Additional Information
Wire Diameter
- 9 Gauge (3.7 mm) side rods and cross rods.
- Cross Rods welded at 16” on center.
- First Cross Rods welded 12” in from each end to allow lap spaces per code requirements.
- Manufactured from a minimum of 95% recycled material.
Comments:
OCM Limited Warranty
All recommendations, statements and technical data contained herein are based on tests we believe to be reliable and correct; however, accuracy and completeness of said tests are not guaranteed and are not provided as an express or implied warranty. User shall rely on his or her own information and tests to determine suitability of the product for the intended use and user assumes all risk and liability resulting from his or her use of the product. In the event that a product supplied by OCM, Inc. proves to not meet the OCM, Inc. published dimensional or other specifications of the product, an OCM, Inc. representative will review such product and circumstances to determine whether a replacement is warranted. OCM, Inc.'s and its manufacturer's sole responsibility shall be to replace, at OCM, Inc.'s sole discretion that product or portion of the product which OCM, Inc. deems to be defective, within six months of the delivery of the product. OCM, Inc. disclaims all other warranties or conditions, whether express or implied, including an implied warranties of merchantability or fitness for any particular purpose. In no event shall OCM, Inc. or its parent or affiliated companies be liable for delay caused by defects, for loss of use, or for any indirect, incidental, special, or consequential damages or for any charges or expenses of any nature whatsoever. In no event shall OCM, Inc.'s liability exceed the purchase price paid for the particular affect OCM, Inc. products.